抗撞击PPS 6150T6日本宝理--DURAFIDE®PPS是本公司从株式会社吴羽采购其制造的线性PPS聚合物,早在日本进行改性生产与销售。与传统的PPS相比,在保持其优异的机械强度、耐热性、耐药品性、阻燃性等特点的同时,提高了延展性及抗冲击强度,使韧性更好。被广泛应用于汽车发动机周边部品及混合动力汽车/电动汽车的电气部品,智能手机、浴室及盥洗室的混合水long头等。
抗撞击PPS 6150T6日本宝理--DURAFIDE® 6150T6是一种聚苯硫醚(PPS)产品,含有的填充物为50%玻璃\矿物
Impact resistant PPS 6150t6 Burley durafide? PPS is a linear PPSpolymer purchased by our company from Wu Yu, Ltd., which was firstmodified, produced and sold in Japan. Compared with the traditionalPPS, while maintaining its excellent mechanical strength, heatresistance, drug resistance, flame retardancy and othercharacteristics, it improves the ductility and impact strength,making the toughness better. It is widely used in the peripheralparts of automobile engine, the electrical parts of hybrid electricvehicle / electric vehicle, the hybrid faucets of smart phones,bathrooms and washrooms, etc.
<成型时的注意事项>
· 推荐材料的预干燥条件为140℃、3小时。
· 为了防止树脂分解,请按下列条件设定树脂温度及机筒内的滞留时间。
1) zui佳树脂温度:300 ~320 ℃ (不得超过360℃)
2) 料筒内滞留极限时间
料筒温度 | 滞留时间 |
300℃ | 60分钟以内 |
320℃ | 30分钟以内 |
(上述为参考值,随条件而变)
· 当树脂出现分解或有分解的迹象时,请降低机筒温度,并将机筒内的材料彻底排清。在作业时请带好防护眼睛,不要将手、脸靠近喷嘴处。
· 请勿混入宝理塑料公司推荐外的着色剂、添加剂及异种牌号的树脂。
· 在工作场所应为局部或完全通风。