Phenylenesulfide specific gravity: 1.36 g/cm3 shrinkage rate:0.7%Molding temperature: 300-330℃. It is a kind of thermoplasticspecial engineering plastic with excellent comprehensiveperformance. Its outstanding characteristics are high temperatureresistance, corrosion resistance and superior mechanicalproperties. PPS is sulfur-containing aromatic polymer, linear PPScrosslinked at 350℃ or more into thermosetting plastic, branchedchain structure PPS for thermoplastic.PPS is called polyphenylenesulfide in Chinese. It is hard and brittle, high crystallinity,difficult to burn, good thermal stability, high mechanicalstrength, excellent electrical performance, chemical corrosionresistance and other characteristics. PPS is one of the varietieswith the best heat resistance in engineering plastics. The thermaldeformation temperature of materials modified by glass fiber isgenerally greater than 260 degrees, and its chemical resistance issecond only to polytetrafluoroethylene. In addition, it also has asmall shrinkage molding, low water absorption, good fireresistance. Good shock fatigue resistance, strong resistance toelectric arc, especially at high temperature. Excellent electricalinsulation in high humidity. However, its disadvantages are largebrittleness, poor toughness and low impact strength. Aftermodification, the above disadvantages can be overcome and excellentcomprehensive performance can be obtained
基本信息黄卡编号E107854-100055580特性 延高的拉伸率粘度,高RoHS 合规性 联系制造商加工方法挤出物理性能额定值单位制测试方法密度 1.34g/cm³ISO 1183 吸水率 (饱和,23°C)0.020%ISO 62 粘度 430Pa·s内部方法 硬度额定值单位制测试方法洛氏硬度(M 计秤)93ISO 2039-2 机械性能额定值单位制测试方法拉伸模量4000MPaISO 527-2/1A/1 拉伸应力 (断裂)88.0MPaISO 527-2/1A/50 拉伸应变 ISO 527-2/1A/50 屈服 3.0%ISO527-2/1A/50 断裂15%ISO 527-2/1A/50 弯曲模量 (23°C)4100MPaISO 178 弯曲应力 (23°C)141MPaISO 178 冲击性能额定值单位制测试方法简支梁无缺口冲击强度(23°C)200kJ/m²ISO 179/1eU热性能额定值单位制测试方法玻璃转化温度 190.0°CISO 11357-2 熔融温度 2275°CISO 11357-3线形热膨胀系数 ISO 11359-2 流动 4.0E-5cm/cm/°CISO 11359-2 横向4.2E-5cm/cm/°CISO 11359-2 电气性能额定值单位制测试方法介电强度 30kV/mmIEC 60243-1介电常数 ASTM D150 10kHz 3.00ASTM D150 1 MHz 3.00ASTM D150 注射额定值单位制干燥温度 110 到 120°C干燥时间3.0 到 4.0hr建议的Zui大水分含量 0.020%