PPA AF-1133 VO阿莫科--
注塑时熔融温度在615—650°F范围内，物料在机筒内的停留时间不超过10分钟，这样注塑出来的产品机械性能。要求模具温度至少275°F，以便得到完全结晶和尺寸稳定性的产品。具有部分厚壁的部件，由于冷却速度慢，可以在较低的模温下注塑。模温对于成品部件的表面外感化是至关重要的。用于真空镀金属成电镀金属的矿物填料级PPA树脂的模具表面温度要求350°F。
广的温度范围内和高湿度环境中保持其优越的机械特性－强度、硬度、耐疲劳性及抗蠕变性。增韧品级PPA结合优越的韧度与一定范围的硬度和柔性，扣件中要求一次性使用的刚性、以及重复性使用中挠屈性的良好选择
Amodel AS-4145HS Solvay Specialty Polymers PPA
Amodel AT-1001L Solvay Specialty Polymers PPA
Amodel AT-1002HS Solvay Specialty Polymers PPA
Amodel AT-1116HS Solvay Specialty Polymers PPA
Amodel AT-1125HS Solvay Specialty Polymers PPA
Amodel AT-6115HS Solvay Specialty Polymers PPA
Amodel AT-6130HS Solvay Specialty Polymers PPA
Amodel DW-1150 Solvay Specialty Polymers PPA
Amodel ET-1000HS Solvay Specialty Polymers PPA
Amodel FC-1140 Solvay SpecialtyPolymers PPA
Amodel FC-1150 Solvay SpecialtyPolymers PPA
Amodel HFFR-4133 Solvay Specialty Polymers PPA
Amodel HFZA-1133L Solvay Specialty Polymers PPA
Amodel HFZA-1145L Solvay Specialty Polymers PPA
Amodel HFZA-4133L Solvay Specialty Polymers PPA
Amodel HFZA-4440L Solvay Specialty Polymers PPA
