PA9T GT2330日本可乐丽

PA9T GT2330日本可乐丽---GT2330由于具有高延展性，非常适合在销装配过程中需要高强度的部件。

PA9T高耐热性聚酰胺树脂9T又称尼龙9T，PA9T是可乐丽GENESTAR事业部(Kuraray Co Ltd GenestarDivision)，运用独自之单体合成的高耐热尼龙树脂，具有芳香环（苯环）和高ji脂肪族（长烃链）特殊化学构造。

PA9T high heat-resistant polyamide resin 9t is also known asnylon 9t. PA9T is a high heat-resistant nylon resin synthesized byKuraray Co Ltd genestar division using its own monomer, which hasspecial chemical structures of aromatic ring (benzene ring) andhigher aliphatic group (long hydrocarbon chain).

PA9T工艺：

干燥条件：＜Genestar＞将含水率管理1000ppm以下。结晶速度快，冷却时间短包装材料使用了铝制防湿袋，开封后可立即进行成型加工。开封后自然放置的颗粒会因吸湿而导致含水量上升，需要进行重新干燥。关于重新干燥的条件，如果使用热风干燥机，则请以120℃、5小时左右为参考标准。干燥温度的上限推荐140℃、干燥时间推荐24小时以内。成型条件：熔点：306℃推荐料筒温度：310-330 ℃ 玻璃转化温度：125℃ 推荐模具温度130-140℃

PA9T process:

Drying conditions: < genestar > manage the moisturecontent below 1000ppm. Fast crystallization speed, short coolingtime, packaging materials using aluminum moisture bags, can beimmediately formed after opening. However, the moisture content ofnaturally placed particles after unsealing will increase due tomoisture absorption, which needs to be re dried. For the conditionsof re drying, if the hot air dryer is used, please take 120 ℃ andabout 5 hours as the reference standard. In addition, the upperlimit of drying temperature is recommended to be 140 ℃ and thedrying time is recommended to be within 24 hours. Moldingconditions: melting point: 306 ℃, recommended barrel temperature:310-330 ℃, glass transition temperature: 125 ℃, recommended moldtemperature: 130-140 ℃